Installation InstructionsImportant Note: The Direct Wire SmartCord must be installed by someone familiar with automotive electrical systems. If in doubt see your car dealer or a car radio installer. The direct wire cord comes with connector to allow easy hook-up to your car's electrical system. The black ground wires is fitted with a lug to allow it to be installed under any ground screw under your vehicle's dashboard. The red/black striped wire for +12 volts is fitted with an insulated 1/4" male spade lug. We also have supplied a special 3M connector (in blue) that allows you to tap into an existing wire in your vehicle. This connector can be used only with wire gauges 14 through 18.To install the connector position it around the wire you wish to tap into and squeeze it with pliers until the halves snap together. It is recommended that you tap into "switched" circuit of the vehicle - one that is on when the vehicle is on and off when the vehicle is off. The direct wire can then be plugged into this connector. Make sure the clear insulator sleeve on the direct wire completely covers the connection.
| | Escort Direct Wiring Cord for Radar Detectors |  | 19.99 |  |
Direct Wire Cord for Escort and Bel Radar Systems |  | 14.95 | | |
 | Escort Direct Wiring Cord for Radar Detectors |  | 19.99 | |
 | Escort Direct Wire Cord 79-001059-01, 1 ea |  | 14.95 | |
No comments:
Post a Comment